Cross-Hatching Across Satin Stitches

This one was a bit of a challenge --- but then again, I just LOVE a challenge! I received an embroidered quilt top that just "demanded" to be cross-hatched in the center. I didn't want to stitch across any of the letters, because that would squash the satin stitches. I also didn't want to do tie-offs at every letter, though.... so I came up with this little technique for "cheating".

Do the cross-hatching as you normally would. Take a close look at the small photo that shows a close-up of the letter with the crystal in it. If you look at the blue satin stitch portion of the letter itself, you can see where I "jumped" over the blue portion of the letter during the cross-hatching process. The width of the jump stitch is less than 1/4 of an inch, but if I had stitched right through the letter, it would have crushed the satin stitches.

This was done with white thread, so as a result there were little tiny white jump stitches showing on most of the letters. I went to the fabric store, and bought a fine tip permanent fabric marker -- the kind with the tiny micron tip -- in exactly the same shade of blue as the letters. That's the most critical part -- matching the thread color.

Now, all you have to do is "color" the white thread that is laying on top of the satin stitches. The single thread will fade into the background of the satin stitches, and look just like another single stitch. On the back of the quilt, you will not want to cut those tiny stitches, or there will be some unraveling of your cross-hatching in the future.

For the jumps over the pink floral portion of the quilt, I did tie-offs, and started again on the other side.

And by the way, this alphabet is available in a beautiful heirloom collection from Platinum Embroidery! You will also be able to read a newsletter that has all of the instructions for making this wall-hanging project! Here's a link to the page that shows the entire collection:

Platinum Embroidery Make It Special Heirloom Collection

These letters stitch out beautifully! Enjoy!

Machine Applique part two

Here is another example of using embroidery and appliqué before the quilt is assembled. In this tablecloth, I appliquéd all of the small white squares first on the white tone-on-tone fabric, and then cut them to size and assembled each quilt square. The assembly of the quilt was much faster, because I was able to treat each appliquéd square just like a regular piece of the block. I know that I would have had a hard time trying to appliqué all of the squares if the quilt had already been assembled. I know lots of people who can do it that way, but I'm just not that brave! LOL!

Machine Applique

Machine embroidery is shown on this quilt in two different ways. I digitized the appliqué designs, and used a blanket stitch for the edges. I wanted the soft look that blanket stitches can give over time, with just a touch of fraying through the stitches. This quilt was for my daughter's sixteenth birthday -- I can't believe it's been 4 years ago already!

You can use any of your existing appliqué designs if you have the digitizing software to enable you to change the satin stitches along the outer edge to a blanket stitch. As I mentioned, the edges will fray just a tiny bit over time, but that adds a soft look to the quilt.

For the lettering, I embroidered on the white fabric before I assembled the quilt. All of the bobbin thread from the embroidery and the appliqué is hidden inside of the quilt layers.

This little lap quilt has seen a lot of hugging over the past four years, but it just gets better with age.

Paper Piecing

Lots of discussion has centered around the topic of adding embroidery to quilts --- and the main question is always "Do I make the entire quilt first and then add the embroidery, or do I embroider the pieces and then make the entire quilt?"

I prefer to embroider the individual pieces first, and then create the entire quilt. The embroidery process shrinks the pieces by pulling in on them. Your pieces should be embroidered first, and then cut to the proper size to accurately fit your quilt blocks.

In this example, the names of various boats and their owners were embroidered first on the red fabric. After pressing the pieces with a tiny bit of starch, I used them for the paper-piecing process on this quilt. This allowed me to use a tear-away/wash-away stabilizer that will add body to the lettering, but the bulk of the stabilizer (the part that was not under the lettering) will wash out of the quilt over time. Also, there will not be any bobbin thread from the embroidery showing on the back of the quilt.

Adding hand stitches to machine quilting

I just love where machine quilting is headed these days -- the effects that are achieved are truly amazing. Sometimes, though..... I just want to sit down and stitch by hand. Oh, sure -- I'm still doing the binding by hand, but that's not quite the same as doing quilting stitches. I guess you could say I've missed it a bit, since I was a hand-quilter for so long.

If you do any machine quilting (long arm or short arm), and you want to add something really special and fun to your quilts, try adding just a touch of hand stitching!

Here is a little whole cloth quilt that I did a few months ago.

I thought it would look nice with a little touch of color in the center. Here is a close-up of the machine embroidery that was added.

You can see that there are also hand quilted stitches a quarter of an inch away from the machine stitches. I like the effect of the two types of stitches combined! Each of the corners had a little heart inside of a square, and I think it really softens things up a bit when there are a few extra stitches added.

Candy Apple Quilts

I'd like to share a few pictures with you of a quilt that I have just finished called Scrappy Mountain Majesties. This was done with a pattern that I saw at Quiltville, and it was tons of fun! I used up lots of different shades of green from my stash. You could use any combination of colors to create a truly scrappy quilt in all different colors. It's also a fun project to do with friends, because you can take full advantage of the "assembly line" style of sewing.







Here's a close-up of the quilting used on this project. The patterns I used are called Gilded Deluxe Friends, and they are available through Anne Bright.







Anne's patterns always have coordinating borders, squares, triangles, etc.... and just really brighten up any quilt that I have used them for. These designs are for use with a Statler Stitcher -- the computer-aided long arm quilting machine made by Gammill.